Every finished product you serve to your customers goes through a number of steps from growing, harvesting, and shipping to receiving, prepping, and serving. In each one of these steps, potential food safety hazards that might sicken or injure the final consumer are present. However, with careful planning, these hazards can be prevented, reduced to safe levels, or even eliminated altogether. Keep reading to learn what a HACCP plan is and the steps needed to create your own. What does HACCP Stand For? HACCP stands for Hazard Analysis and Critical Control Points. It is a system restaurant operators put in place to help them identify and react to dangerous biological, chemical, or physical food contamination. The goal of this food management s
Sharpening on the other hand is reupholstering the furniture or telling the hair stylist to give you a new look. Material is going to be removed from the edge of the blade. There’s no way around it. How much is removed will be a function of just how dull the knife has become or whether you’re sharpening to compensate for a chip in the edge or because the tip has broken off. If your knife is not damaged and you have it sharpened twice a year very little material will be removed each time, yet it may still be enough for you to notice just by looking carefully with the naked eye.
Place an old coffee mug upside down so that the bottom of the mug is exposed to the air. In a pinch, a coffee mug can serve as a surprisingly effective sharpening tool if you don't have any fancy equipment. The ceramic material of a mug is a material coarse enough to get good results. Indeed, some honing rods even use ceramic material to keep a blade homed in between sharpenings.
High Grit Stones: These are also known as finishing stones with the number range going up to 8000, and give you a super refined edge. They work great with Western knives as they cutting edge resembles a “U” as opposed to a “V”. If you are using your knife to cut meat, then you can happily stop at 4000 or 6000 grit. If you are only using it for vegetables or fruit go all the way to the 8000.
A: For many years there was a heated debate around this topic with manufacturer’s stating flatly the notion their products actually damaged knives was absurd, and many professional chefs claiming not only was it not absurd, it was common for mechanical sharpeners to damage expensive cutlery. So who was right? To a certain extent they both were. The manufacturers were correct in asserting that if you followed the instructions to the letter there was little if any chance your knives would be damaged. However, in reality few people actually followed the instructions to the letter and when they veered from the recommended course the potential was there for damage.