Begin with your lower-grit stone. Place the heel of your knife on the far edge of the stone, holding the blade gently but firmly with both hands at a 15- to 20-degree angle. Using even pressure, slowly drag the knife over the stone toward you down the length of the stone while simultaneously moving the knife such that the contact point moves toward the tip of the blade.
Both Belgian Blue and Vielsalm Coticule are ancient stone layers found in the Belgian Ardenne Mountains with characteristics similar to both Novaculite and Siliciclastic sedimentary stone in that it is a metamorphic stone consisting of both gray and yellow volcanic ash mixed with tiny Spessartite Garnet crystals suspended in a clay matrix. However, due to its geology, both types of stone occur only in vertical seams sandwiched between two thick layers of bluish-purple slate and thus, they must be meticulously extracted mostly by hand. However, this type of extraction process is both very time-consuming and very labor-intensive and, quarrymen can only extract the stone for a few months each year due to inclement weather conditions. Consequently, both Belgium Blue and Coticule whetstones tend to be somewhat expensive.
As opposed to water whetstones that require you to pre-soak the stone, the Norton oil stone is pre-filled with oil to save time and eliminate the need to pre-soak it prior to use and the lubricant stays on the surface during sharpening. The oil also prevents metal from bonding with the abrasive surface by flushing away dislodged abrasive and metal chips.
Grit choices should fall in line with the steel used to make the knives you plan to sharpen. If your knives are all European, relatively soft steel knives, then you could finish off your knives at the 1,000 – 2,000 grit level. There is a lengthy explanation regarding this topic but suffice it to say that at 2,000 grit, these knives can be made extremely sharp.
You might not need to spend hundreds of pounds to get the best knife sharpener, but you do need to know what you're doing. Warner gave me a crash course in the technique. As a newbie to this method, it took a while to get used to (especially since Warner handed me a knife that had never previously been sharpened) but after half an hour's practice and a little encouragement, I got the hang of it. Here's what I learned...
About a year ago, we wrote an article on why every man should carry a pocket knife. A lot of you out there agreed that the pocket knife deserves a permanent place in every man’s pocket. After we wrote the post, we started getting emails from men who were first time pocket knife owners asking how to sharpen their new prized possession. Well today we’re going to answer that question.
Steeling helps maintain sharpness. This process realigns the edge, correcting for dulling causes such as a rolled edge. A sharpening steel is a type of hardened cylindrical rod used similarly to honing stones. For example, a butcher steel is a round file with the teeth running the long way, while a packer steel (used in the meat packer's industry) is a smooth, polished steel rod designed for straightening the turned edge of a knife, and is also useful for burnishing a newly finished edge. Because steels have a small diameter they exert high local pressure, and therefore affect the knife metal when used with very little force. They are intended for mild steel knives that are steeled several times a day, but are not well suited for today's tougher and harder blade steels. Diamond steels are now available that have an industrial diamond coating and can remove blade metal as well as straighten, therefore used correctly they can re-profile a knife instead of just honing.