As the video of our test shows, the Trizor XV took a very dull, very heavy (and slightly bent) 12-inch Wüsthof chef’s knife and made it tomato-slicing sharp. Setting the new edge took about 20 strokes on the coarse wheel; the fine and polishing steps took about 10 and five strokes respectively. All told, the process was perhaps three minutes of work. The motor was impressively powerful, never allowing the sharpening wheels to bog down or “catch” in the metal of the knife. It sharpened blades to within about ⅜ inch of the heel—as with the manual ProntoPro 4643, excellent performance, and a testament to the attention that Chef’sChoice pays to overall design throughout its extensive product range. This sharpening of virtually the entire blade is important. Without it, not only do you lose the ability to cut with the heel of the knife—especially useful when you’re cutting tough root vegetables, where employing the heel provides stability and pressure—but also over time the blade edge develops a “dish,” or dip, that prevents the rear portion of the blade from contacting the cutting board and slicing all the way through a food item.
Put the pointed, narrow end of the sharpener up against the open end of the gut hook. The narrow, pointed end of the sharpener should face in toward the thickness of the blade, away from the edge of the gut hook. Match the angle of the sharpener to the original edge angle. This will maintain the correct sharpening angle and prevent you from getting cut by the blade tip. Hold the same angle when sharpening each side of the gut hook.
The angle on a Buck Knife is set based upon how we feel the knife will be used. Heavy use needs a strong and blunt "V" while skinning or filleting would need a deeper but more vulnerable "V". We tend to grind to 13-16 degrees per side (see illustrations). If you match the existing edge angle and hold the knife against the stone to cut evenly across the edge grind, you will produce an edge with a similar angle.
The truth is that there is no one recommendation that we can make that will meet everyone’s needs. Every sharpener’s needs are different and every sharpening toolkit will be different. In order to help beginning sharpeners get started with good sharpening stones to build around, we need to understand their individual needs. So with that in mind, let’s look at the basic needs of a beginning sharpener.
Meanwhile, if you want something that you can use to sharpen a variety of knives and edges, including small and pointed tools, you might want to consider the DMT WM8CX-WB 8-Inch Duo Sharp Plus Bench Stone – Coarse/Extra Coarse with Base. For less than a hundred bucks, you can even use it to repair a damaged edge because of its extra-coarse diamonds.
The stick – With a stick sharpener hold the sharpener in front of you (facing away from you) with one hand and the handle in the other hand. Hold the base of the knife against the base of the tip at a slight angle and then push the blade along the stick pulling it across the stick at the same time. The tip of the blade should cross the end of the stick. To sharpen the other side of the blade place it under the stick and repeat the process making sure to reverse the angle at which you are holding the knife against the stick.
http://www.youtube.com/user/MakeSushi1 is all about how to make sushi, we pride ourselves on creating new exciting sushi roll recipes and then sharing them with the world. In our video tutorials we will teach you how to do all a basics of making sushi and create innovative sushi rolls, sashimi, nigiri sushi and possibly might create a new category of sushi , who knows. Subscribe to our YouTube channel to be notified of our weekly sushi videos: http://www.youtube.com/subscription_c...