I like the fact that there are two different grits (can be seen as two colors). the black rubber feet stick to the kitchen granite top like glue. The 1000 does a pretty good job of getting a knife roughly there and the 4000 puts on a fine polish for razor a sharp edge. I would go the extra step of stropping the knife after the grinding operation for an extra sharp edge.
Low Grit Stones: A sharpening stone with grit number less than a 1000 is generally used for knives and tools that are damaged. If your blade has any nicks or chips in the blade, the stones will take care of them in a jiffy! They usually have a coarse side for nicks and chips, with the other side for general sharpening. Even if the knife’s edge has become totally blunt, the stone will re-sharpen it perfectly.

Table mounted device – Typically the manual powered table mounted sharpener looks virtually identical to the electric powered sharpener with a slot for each stage. Where they differ is that each slot in the manual powered sharpener has only one groove and you pull the blade through this groove toward you to sharpen the blade. Once the blade is sufficiently sharp you place it in the honing groove to refine the edge and pull it toward you again several times. If there is a third, cleaning, stage you repeat the process for that stage as well.
Removing the burr is fairly simple. You'll need a leather strop or block (this sort of thing), which is designed to catch the metal fibres from the knife. You could do it with a fibrous tea towel or some newspaper if you like, but I'd suggest going with leather to begin with. The motion is fairly similar to sharpening. Draw the knife over the leather, going away from the edge at roughly the same angle as when you sharpened. 
×